Companyleader
HomeApplication areaDocumentsOur partnersAbout Us
Companyleader

Raw and auxiliary materials

DCPD resins

 

ENYDYNE® polyester resins are DCPD based systems with intrinsic environmental advantages and enhanced user value.

The ENYDYNE® thermosetting range includes clear, thixotropic, pre-accelerated and filled resins particularly recommended for open-mould use. ENYDYNE® resins also give excellent performance in cold press, injection moulding, and pultrusion.

 

 

Benefits for users:

  •  High wet-out allowing faster consolidation, further reduction in styrene emissions during consolidation, and increased filler and reinforcement loading
  •  Rapid increase in barcol hardness, allowing lower surface tack and faster mould turnaround
  •  Reduced fibre print-through
  •  Lower styrene emissions by up to 50%

Reference 

Comment


 PDF-file


ENYDYNE E9045 Standard DCPD Resin
PDF

ENYDYNE K 00-6226 TAE

Less than 32% styrene content.  Emissions are cut by 50% compared to standard DCPD resin


 

PDF


ENYDYNE H 63380 TA

General purpose resin – from 16 to 40 minutes gel time at 25°C,  depending on catalyst nature and level


 

PDF



 

ENYDYNE H 63372 TA

General purpose resin – from 12 to 50 minutes gel time at 25 °C,  depending on catalyst nature and level


 

PDF



 
 

Contact with us:

WE HAVE MOVED!!!!

NEW ADDRESS:

Str. Ushinskogo 40, of. 503

03151, Kiev, Ukraine

Watch on Yandex map

 

GENERAL TEL./FAX.:

+38 (044) 496-21-56

ADDITIONAL:

+38 (044) 451-73-57